LW-PLALarge wing and fuselage sections
Best starting point for long, lightweight sections when expansion is calibrated.
AIRCRAFT 03 · CONFIGURED TO ORDER
Survey Wing
An efficient fixed-wing 3D model for mapping, surveying, and longer-duration coverage, configured around the sensor, ground resolution, area, wind, and printer available to the operator.
- Digital package
- Custom 3D model set
- Mission focus
- Mapping and endurance
- Configuration
- Sensor and printer review
- File price
- From $149
The final geometry, print profile, and verified component list are delivered after mission coverage, sensor, printer, and operating requirements are reviewed.
AIRCRAFT SPECIFICATIONS
Wingspan1400 mm
AUW · all-up weight3.8 kg
Range24 km
Speed88 km/h
Print profileTo configure
Build volumeTo confirm
Payload capacityNot verified
EnduranceNot verified
Wingspan, AUW, range, and speed are illustrative website values carried over from the shop, not measured specifications or approved design targets.
Aircraft 2D view
DRAWINGTOP / SIDE / FRONT
Dimensioned aircraft drawing not yet supplied.
Electrical overview
SYSTEM CONCEPTPOWER
Battery → power distribution → motor controllers → motors
CONTROL
Navigation sensors → autopilot → motor controllers
GROUND LINK
SarumanOS ↔ telemetry link ↔ autopilot
Conceptual architecture only. Connector pinouts, voltages, and the aircraft-specific wiring plan are pending.
CFD analysis
RESULTS PENDINGNo simulation results have been supplied. Charts will show measured CFD output when a validated dataset is available.
Survey Wing print profile
FABRICATIONThe Survey Wing uses lightweight sections for endurance, with LW-ASA and PA6-CF reserved for exposed and load-bearing components. Always validate on your exact printer and filament brand before producing flight parts.
LW-ASAUV exposed skins and service panels
Use for outdoor-facing parts that need more heat and weather resistance.
PA6-CFSpars, motor mounts, and brackets
Use a hardened nozzle and dry filament path; validate fit after shrinkage tuning.
SLICER SETUP REFERENCES
Download setup references
JSON setup references for Bambu Studio and OrcaSlicer. Review the values in a text editor; direct slicer import has not been validated.
Build essentials
3D MODELPrint settings and component selection are defined during aircraft configuration. Final hardware BOM and aircraft-specific user manual are pending.